MIDI Control in SoundSwitch

New in SoundSwitch 1.3 is MIDI Mapping. You can now map a number of functions in SoundSwitch to your DJ controller or MIDI device. 

To start using the new MIDI feature, plug in your MIDI device, open SoundSwitch and then click the "Midi" button at the top right hand corner of the screen.

Screen_Shot_2017-07-27_at_4.01.37_PM.png

This will bring up the MIDI settings screen as shown below:

Screen_Shot_2017-07-27_at_4.06.23_PM.png

Each of the buttons on the main screen can be mapped to a MIDI device and can also be controlled using your Mouse or Trackpad.

The connected MIDI devices are displayed on the left hand side of the screen.

Note: if you do not see your MIDI device close SoundSwitch, reconnect your MIDI hardware and launch SoundSwitch again.

To map a control, right click on the button or slider you would like to map in SoundSwitch.

Mouse_Over.png

SoundSwitch will signal it is ready to receive MIDI.

Waiting_for_midi.png

Then press/twist/move a pad/slider/knob. You will then see the device, channel and key information displayed for that function.

Recieved.png

The control button will now be highlighted blue indicating it is mapped.

Mapped.png



Check out the video below for the full tutorial run down:

Have more questions? Submit a request