Switching Between DJs

Switching Between DJs:

Switching between DJs in the booth is always a tricky process. If at some point you need to make this happen, follow the instructions below to limit any potential issues.

When disconnecting your SoundSwitch hardware unit remove the DMX connector first, followed by the USB cable. Disconnecting the DMX cable first will ensure the lighting rig will remain in its last state, allowing time for the next DJ to setup without the lights turning off.

If you are the next DJ up, make sure you connect the USB cable to the hardware unit first then open SoundSwitch in Performance Mode before plugging in the DMX cable. Making sure you are setup before plugging in the DMX cable will mean the lighting will seamlessly switch to your Scripts or Autoloops without interruption. 

 

Have more questions? Submit a request