SoundSwitch x Prime 4

SoundSwitch supports StagelinQ connection to the Denon DJ Prime 4, 2, and Go controllers.

Note: It's important to remember that this connection type is different from Engine Lighting, which is SoundSwitch running directly on the DJ Hardware. This method is only to be used if you want to connect your hardware to a machine running SoundSwitch.

If you want to use Engine Lighting, please refer to the article below:

https://inmusicsupport.freshdesk.com/en/support/solutions/folders/69000650452

Connection Steps:

Step 1: Connect an Ethernet cable from the Prime 4 StagelinQ port to the computer running SoundSwitch.

Step 2: Open SoundSwitch and enter Performance Mode.

Step 3: Open the SoundSwitch Preferences and select Engine Prime and the All-in-One option as shown below:

Important Note: You will need to restart SoundSwitch for these settings to take effect.

Step 4: Once SoundSwitch has restarted, enter Performance Mode and check the Connection Status icons are showing active as shown below:

This video shows you how to set up the Prime 4 with SoundSwitch.

These steps should help you set up the connection between your Denon DJ Prime 4 controller and SoundSwitch for an enhanced performance experience.